Crankbrothers Eggbeater 1 MTB Pedals

The design for the original crank brothers pedal began out of frustration. The founders of crank brothers, Carl and Frank, were tired of getting stuck in mud-covered pedals with no way in or out. They realised that existing pedals were too complicated It started with a simple question: what is the best way to attach a shoe to a crank? To answer this question, Carl and Frank created a system with only two moving parts hinging on a spring. This system became known as the eggbeater pedal, and later it was adapted into the candy pedal. A word on maintenance In order to keep your crank brothers pedals running smoothly, they recommend the following:

• clean pedals every 30 hours of riding
• remove the pedal body from the spindle and wipe it clean of any dirty grease
• apply fresh grease to the inside of the pedal before re-installing the spindle

Pedal features: 

Excellent mud-shedding: the design is very open
4-sided entry: clip in on all 4 sides of the pedal, by pushing forward or pulling backwards on the
Extremely lightweight: pedal design is very simple with only a few key parts
Increased float: 6° of side-to-side rotational play. The float of the pedal allows for the rid
Fit adjustment: crank brothers premium cleats can be adjusted for 10° release
Customise the fit between your shoe and the pedal by using tread contact sleeves
Crank brothers pedals are fully re-buildable for simple maintenance. There is a consistency in part
When servicing this pedal, use the rebuild kit designed for level 1 & 2 pedals